
Reading Industry Fireplaces, Then Sweeping Them
What Is Your Industry Fireplace Doing?
A stiff damper, a dark smoke shelf, smoke at the start of a fire. Tell us which, and we call back with an Industry day to measure it.
Industry ZIP Codes We Drive To
Your street and ZIP tell us the drive from Rolling Hills Estates. What the fireplace has been doing tells us what to bring.
Matching the Sign to a Service in Industry
If your Industry home has a long-idle fireplace, ask for a measured sweep and a written note before you light it.
Chimney Sweep in Industry
Creosote depth checked at the smoke shelf and in the flue, then cleared with the tool that stage of buildup needs.
Learn MoreChimney Inspection in Industry
Damper, smoke shelf, liner and crown read in order, so each sign is traced to the part behind it.
Learn MoreChimney Repair in Industry
Water marks and loose mortar followed back to the crown, cap or joint where they start, and fixed there.
Learn MoreFireplace Inspection in Industry
A damper that drags or a crack in the firebox panel gets looked at, measured and photographed on the spot.
Learn MoreFireplace Repair in Industry
Damper, refractory and smoke shelf repairs, limited to the part the inspection pointed to.
Learn MoreChimney Level 2 Inspection in Industry
A camera run of the whole flue for a sale or after a quake, with stills of the joints and the creosote.
Learn MoreChimney Cap Installation in Industry
A cap sized from the flue tile measurement, for when rain marks or nesting debris show up below.
Learn MoreChimney Flashing Repair in Industry
A ceiling stain beside the chimney traced to the flashing seam, then resealed or replaced there.
Learn MoreChimney Masonry Repair in Industry
Joints probed for depth before repointing, with mortar matched in color to the brick around them.
Learn MoreChimney Rebuilds in Industry
Partial or full rebuilds when a lean or through-cracks go beyond what repointing can hold.
Learn MoreFireplace Cleaning in Industry
Ash, soot film and cloudy glass cleared, with any glazed creosote at the throat noted for you.
Learn MoreGas Fireplace Cleaning in Industry
A lazy yellow flame or soot on the glass traced to the burner, pilot or logs and cleaned there.
Learn MoreGas Fireplace Repair in Industry
A pilot that drops out is tested part by part until the one failed part is found.
Learn MoreFireplace Remodel in Industry
New surrounds and mantels planned after the firebox and flue are read for wear.
Learn MoreFireplace Inserts in Industry
Inserts sized from the firebox opening and flue measurements, with the liner they need.
Learn MorePellet Stove Repair in Industry
Auger, igniter, blower and board tested in turn until the fault shows itself.
Learn MoreWood Stove Repair in Industry
Smoke at the door or a slow burn traced to the gasket, baffle or firebrick behind it.
Learn MoreGas Logs in Industry
Log sets sized from the firebox and room measurements, vented or ventless.
Learn MoreWhat Industry fireplaces tend to tell us
With around 40 homes, this city is almost entirely commercial. If yours is one of them, the census figures are too rough to say much, so the fireplace itself is the only useful source of information, and it should be measured. Winter rain falls mostly November through March, and Santa Anas can blow across the Puente Valley. Chino Hills in 2008 was centered a short way east and felt here, reason enough to check any old brick.
The Houses
Typical of our Industry calls: a tiny number of houses, about 40 housing units, among rail lines, warehouses and historic homestead buildings.
The Sign Most Often Reported
A fireplace in one of very few houses here that has sat cold through several winters in a row.
How We Measure It
Soot and debris in the flue, and damper movement, with a note on how long it has been idle.
How It Gets Cleared
Long-idle debris is cleared and photographed, then a light sweep finishes the job if the reading calls for one.
Describe the Sign
Tell us what your Industry fireplace is doing.
We measure the creosote behind that sign on the visit, then clear the flue and show you the before and after photos.
