
Reading Irvine Fireplaces, Then Sweeping Them
What Is Your Irvine Fireplace Doing?
A stiff damper, a dark smoke shelf, smoke at the start of a fire. Tell us which, and we call back with an Irvine day to measure it.
Irvine ZIP Codes We Drive To
Your street and ZIP tell us the drive from Rolling Hills Estates. What the fireplace has been doing tells us what to bring.
Matching the Sign to a Service in Irvine
Newer Irvine homes can start with a measured check, and a brush pass follows only if the numbers justify it.
Chimney Sweep in Irvine
Creosote depth checked at the smoke shelf and in the flue, then cleared with the tool that stage of buildup needs.
Learn MoreChimney Inspection in Irvine
Damper, smoke shelf, liner and crown read in order, so each sign is traced to the part behind it.
Learn MoreChimney Repair in Irvine
Water marks and loose mortar followed back to the crown, cap or joint where they start, and fixed there.
Learn MoreFireplace Inspection in Irvine
A damper that drags or a crack in the firebox panel gets looked at, measured and photographed on the spot.
Learn MoreFireplace Repair in Irvine
Damper, refractory and smoke shelf repairs, limited to the part the inspection pointed to.
Learn MoreChimney Level 2 Inspection in Irvine
A camera run of the whole flue for a sale or after a quake, with stills of the joints and the creosote.
Learn MoreChimney Cap Installation in Irvine
A cap sized from the flue tile measurement, for when rain marks or nesting debris show up below.
Learn MoreChimney Flashing Repair in Irvine
A ceiling stain beside the chimney traced to the flashing seam, then resealed or replaced there.
Learn MoreChimney Masonry Repair in Irvine
Joints probed for depth before repointing, with mortar matched in color to the brick around them.
Learn MoreChimney Rebuilds in Irvine
Partial or full rebuilds when a lean or through-cracks go beyond what repointing can hold.
Learn MoreFireplace Cleaning in Irvine
Ash, soot film and cloudy glass cleared, with any glazed creosote at the throat noted for you.
Learn MoreGas Fireplace Cleaning in Irvine
A lazy yellow flame or soot on the glass traced to the burner, pilot or logs and cleaned there.
Learn MoreGas Fireplace Repair in Irvine
A pilot that drops out is tested part by part until the one failed part is found.
Learn MoreFireplace Remodel in Irvine
New surrounds and mantels planned after the firebox and flue are read for wear.
Learn MoreFireplace Inserts in Irvine
Inserts sized from the firebox opening and flue measurements, with the liner they need.
Learn MorePellet Stove Repair in Irvine
Auger, igniter, blower and board tested in turn until the fault shows itself.
Learn MoreWood Stove Repair in Irvine
Smoke at the door or a slow burn traced to the gasket, baffle or firebrick behind it.
Learn MoreGas Logs in Irvine
Log sets sized from the firebox and room measurements, vented or ventless.
Learn MoreWhat Irvine fireplaces tend to tell us
William Pereira's master plan shaped Irvine from the 1960s, and half the homes are newer than 2002. Metal or gas units are the norm, so what we check here is usually a thin flue or a burner, and a homeowner association may also have a say. Winter is mild here, and rain falls mostly from November to March. Fall and winter Santa Anas are the bigger test for a metal cap, and the 2007 Santiago Fire burned through foothills to the northeast.
The Houses
Typical of our Irvine calls: stucco and tile houses and condos, nearly all with factory-built metal or gas fireplaces rather than masonry.
The Sign Most Often Reported
A burner or factory-built unit that started smelling different, or a cap loosened during a dry windstorm.
How We Measure It
Soot or film level, cap fastening, and whether the unit looks like it has any moisture entering.
How It Gets Cleared
Metal and gas units get cleaned only as far as the reading calls for, then photographed.
Describe the Sign
Tell us what your Irvine fireplace is doing.
We measure the creosote behind that sign on the visit, then clear the flue and show you the before and after photos.
